Cisco Systems N5KC5548UPFA, N55M4Q manual Fault top and OK bottom LEDs Handle Release lever

Chapter 1 Overview

Cisco Nexus 5000 Platform Switches

Se n d d o c u m e n t a t i o n c o m m e n t s t o n ex u s 5 k d o c s @ c i s c o . c o m .

A	Group 1, ports 1 through 16: 10-Gigabit	D	Groups 2 and 3, ports 1 through 4: Encrypted
	Ethernet and 1-Gigabit Ethernet-capable		Ethernet ports
	Encrypted ports
B	Group 1, ports 1 through 32: Unencrypted	E	Groups 2 and 3, ports 5 through 6:
	Ethernet ports		Unencrypted Ethernet ports
C	Group 1, ports 33 through 40: Encrypted
	Ethernet ports

Power Supply

The Cisco Nexus 5020 switch uses a front-end power supply with front to back airflow. The chassis has slots for two power supplies. Two power supplies can be used for redundancy, but the Cisco Nexus 5020 switch is fully functional with one power supply. Figure 1-39shows the power supply, which has two LEDs: one for the power status and one for the failure condition.

Figure 1-39 Power Supply for the Cisco Nexus 5020 Switch

3

2 1

1	FAULT (top) and OK (bottom) LEDs	3	Handle
2	Release lever

186264

For descriptions of the LEDs, see Table D-1 on page D-2. For descriptions of power supply conditions indicated by the LEDs, see Table D-2 on page D-3.

If you have one power supply installed in the chassis, but the other power supply slot is empty, you should use a power supply blank panel to cover the empty slot. Figure 1-40shows a blank power supply panel.

	Cisco Nexus 5000 Series Hardware Installation Guide
OL-15902-01		1-37