Cisco Systems N5KC5548UPFA, N55M4Q manual Replacing Components

Se n d d o c u m e n t a t i o n c o m m e n t s t o n ex u s 5 k d o c s @ c i s c o . c o m .

C H A P T E R 4

Replacing Components

This chapter describes how to remove and install components for the Cisco Nexus 5500 Platform switch or the Cisco Nexus 5000 Platform switch.

This section includes the following sections:

•Replacing an I/O Module for a Cisco Nexus 5548 Switch, page 4-1

•Replacing Expansion Modules, page 4-5

•Replacing or Installing Power Supplies, page 4-8

•Replacing a Fan Module, page 4-13

•Removing the Cisco Nexus 5500 Platform Chassis or the Cisco Nexus 5000 Platform Chassis, page 4-17

Caution To prevent ESD damage, wear grounding wrist straps during these procedures and handle modules by the carrier edges only.

Replacing an I/O Module for a Cisco Nexus 5548 Switch

To replace an I/O module with another I/O module (Layer 2 I/O module or layer 3 I/O module) you must remove the right fan module and then pull the I/O module out using the handle of the left fan module, which is installed in the middle of the I/O module. You then install the replacement I/O module and fill its fan module slots with the fan modules from the original I/O module.

Note If the module includes the product ID on the front, it is a Layer 3 I/O module (product ID N55-D160L3 or N55-D160L3-V2). The N55-D160L3-V2 uses a newer version of the Layer 3 ASIC and enables higher table sizes in a future software release from 8K host entries to 16K host entries or from 4K multicast routes to 8K multicast routes (IPv4). The Layer 2 module (product ID N55-DL2) does not include the product ID on the front.

Cisco Nexus 5500 Platform and Cisco Nexus 5000 Platform Hardware Installation Guide

OL-15902-01 4-1