Send documentation comments to nexus5kdocs@cisco.com.
2-13
Cisco Nexus 5500 Platform and Cisco Nexus 5000 Platform Hardware Installation Guide
OL-15902-02
Chapter2 Installing the Cisco Nexus 5000 Series Switches
Installing the Switch
Step 2 Install the rack-mount guides on the switch as follows:
a. Position one of the rack-mountbrackets against the side of the switch and align the screw holes as
shown in Figure2-7. Then attach the bracket to the switch with two of the flat-head M4 screws.
b. Repeat with the other rack-mount bracket on the other side of the switch.
Step3 Attach the slider rails to the rack as shown in Figure 2-8. Use two 12-24 screws or two 10-32 screws,
depending on the rack rail thread type. For racks with square holes, insert the 12-24 cage nuts in position
behind the mounting holes in the slider rails.
a. Repeat with the other slider rail on the other side of the rack.
b. Use the tape measure and level to verify that the rails are horizontal and at the same height.
Figure2-8 Installing the Slider Rails
Step4 Insert the switch into the rack and attach it as follows:
a. Using both hands, position the switch with the back of the switch between the front posts of the rack.
b. Align the two rack-mount guides on either side of the switch with the slider rails installed in the
rack. Slide the rack-mount guides onto the slider rails, and then gently slide the switch all the way
into the rack. See Figure 2-9. If the switch does not slide easily, try realigning the rack-mount guides
on the slider rails.
239034
1
1
2
2
1Slider rail with screw holes aligned to screw
holes in rack
2Two customer supplied 12-24 or 10-32 screws
used to attach each slider rail to the rack