Chapter 5 Installing Memory in the Router
Installing and Formatting Compact Flash Memory Cards in Cisco 3631 Routers
Installing and Formatting Compact Flash Memory Cards in Cisco 3631 Routers
This section describes how to install Compact Flash memory cards in Cisco 3631 routers, how to format the cards into a Class B Flash file system (low end file system) or a Class C Flash file system (similar to DOS), and how to perform file and directory operations in each file system. In Cisco 3631 routers, the Compact Flash memory card mounts on a connector on the CPU/mainboard. You can install a Compact Flash memory card with
This document contains the following sections:
•Preventing Electrostatic Discharge Damage, page
•Tools and Equipment Needed, page
•Compact Flash Memory Card Installation and Removal, page
•Formatting Procedures for Compact Flash Memory Cards, page
•File and Directory Procedures, page
Preventing Electrostatic Discharge Damage
Compact Flash memory cards are sensitive to electrostatic discharge (ESD) damage. ESD damage, which can occur when electronic cards or components are handled improperly, results in complete or intermittent failures.
Follow these guidelines to prevent ESD damage:
•Always use an ESD wrist or ankle strap and ensure that it makes good skin contact.
•Connect the equipment end of the strap to an unfinished chassis surface.
•Place a removed Compact Flash memory card on an antistatic surface or in a static shielding bag. If the card will be returned to the factory, immediately place it in a static shielding bag.
•Avoid contact between the card and clothing. The wrist strap protects the card from ESD voltages on the body only; ESD voltages on clothing can still cause damage.
•Do not remove the wrist strap until the installation is complete.
Caution For safety, periodically check the resistance value of the antistatic strap. The measurement should be between 1 and 10 megohms (Mohms).
Tools and Equipment Needed
You need the following tools and equipment to remove and install Compact Flash memory cards:
•
•Antistatic bag or mat
•Number 2 Phillips screwdriver or flat blade screwdriver
Cisco 3600 Series Hardware Installation Guide
| ||
|
