Chapter 10 Cisco WAN Manager Operations
Saving and Restoring Configurations
Table
Name | Description |
|
|
CWM nodename | Specifies the name of the node that has the CWM attached. The node name identifies |
| the gateway node of the destination CWM for the configuration save. As an option, |
| an asterisk (*) indicates that the CWM IP address identifies the destination CWM. |
| Note The value for <CWM nodename> parameter is dependent on the configuration |
| in network.conf file of CWM. |
| When the last field in a /usr/users/svplus/network.conf file entry is set to nwip_on, |
| the <CWM nodename> parameter is the same node where the savecnf command is |
| executed. For example, where <CWM nodename> is specified as nmsbpx14 and the |
| node where the savecnf command is being run is also nmsbpx14. |
| When the last field in a /usr/users/svplus/network.conf file entry is set to nwip_off, |
| the <CWM nodename> parameter is the gateway node name. The gateway node name |
| is specified as the third field in a /usr/users/svplus/network.conf file entry of CWM. |
| For example, the savecnf command saves the configuration of node nmsbpx14 on the |
| CWM workstation, where the IP address is 172.29.23.25, and is connected to the |
| gateway node nmsbpx13. |
| The following example is shown: |
| Last Command: savecnf C051598 nmsbpx14 nmsbpx13 172.29.23.25 |
|
|
destination IP | Specifies an optional parameter for the IP address of the CWM or TFTP network |
| server that is used as the source for the configuration restore. |
| Note This parameter is when an asterisk (*) is entered for CWM Nodename. |
| When more than two CWM workstations are connected to the network, you specify |
| the <destination IP> parameter that identifies the CWM workstation where the |
| configuration save is done. |
| Note You cannot invoke a save configuration of all nodes by specifying an “*” |
| (asterisk) as the third parameter to the savecnf command when nwip_on is |
| configured in the /usr/users/svplus/network.conf file. |
|
|
T | Specifies an optional parameter for TFTP that is used for data transfer instead of the |
| CWM proprietary protocol. |
|
|
pathname | Specifies a new optional parameter that is configured when TFTP is being used for |
| data transfer. The directory path name indicates where the backup files are stored. |
|
|
Step 10 Save the configuration of all routing nodes when nwip_off is configured in the /usr/users/svplus/network.conf file.
The following example shows that the configuration is saved for all routing nodes on the CWM workstation with the 172.29.23.25 IP address, and the CWM gateway node is specified as nmsbpx13. The configuration is saved in the /usr/users/svplus/C051598_Cfgdir directory.
Last Command: savecnf C051598 * nmsbpx13 172.29.23.25
Next Command:
|
| Cisco WAN Manager User’s Guide |
|
| |
|
|
| |||
| Release 15, Part Number |
|
|
|
|
|
|
|
| ||
