Cisco Systems PA-2FE-TX manual fastethernet and slot/port, slot/port-adapter/port interface

Chapter 4 Configuring the PA-2FE

Configuring the Interfaces

Table 4-3 Examples of the interface fastethernet Subcommand for the Supported Platforms (continued)

Platform	Command	Example
Cisco 7301 router	interface, followed by type	The example is for interface 0 of a PA-2FE in port
	(fastethernet) and slot/port	adapter slot 1.
	(port-adapter-slot-number/	Router(config)# interface fastethernet 1/0
	interface-port-number)
		Router(config-if)#
Cisco 7304 PCI port adapter	interface, followed by type	The example is for interface 0 of a PA-2FE in a
carrier card in Cisco 7304	(fastethernet) and slot/port	Cisco 7304 PCI port adapter carrier card in module
router	(module-slot-number/	slot 3 of a Cisco 7304 router.
	interface-port-number)	Router(config)# interface fastethernet 3/0
		Router(config-if)#
Cisco 7401ASR router	interface, followed by type	The example is for interface 0 of a PA-2FE in port
	(fastethernet) and slot/port	adapter slot 1.
	(port-adapter-slot-number/	Router(config)# interface fastethernet 1/0
	interface-port-number)
		Router(config-if)#
VIP in Cisco 7500 series	interface, followed by type	The example is for interface 0 of a PA-2FE on a VIP
routers	(fastethernet) and	in interface processor slot 1.
	slot/port-adapter/port (interface-	Router(config)# interface fastethernet 1/0/0
	processor-slot-number/port-adapter-
		Router(config-if)#
	slot-number/interface-port-number).

Note The PA-2FE is automatically configured with 100-Mbps interfaces. If Cisco IOS software detects that the PA-2FE is connected to a 10-Mbps interface, the PA-2FE will automatically be configured to run at 10-Mbps. Use the speed [10 100 auto] command to manually set the Fast Ethernet speed.

Step 3 Assign an IP address and subnet mask to the interface (if IP routing is enabled on the system) by using the ip address subcommand, as in the following example:

Router(config-if)#ip address 10.0.0.0 10.255.255.255

Step 4 Add any additional configuration commands required to enable routing protocols and set the interface characteristics.

Step 5 Re-enable the interfaces using the no shutdown command. (See the “Shutting Down an Interface” section on page 4-2.)

Step 6 Configure all additional port adapter interfaces as required.

Step 7 After including all of the configuration commands to complete your configuration, press Ctrl-Z—hold down the Control key while you press Z—or enter end or exit to exit configuration mode and return to the EXEC command interpreter prompt.

Step 8 Write the new configuration to NVRAM as follows:

Router# copy running-config startup-config

[OK]

Router#

This completes the procedure for creating a basic configuration. To check the interface configuration using show commands, proceed to the following section, “Checking the Configuration.”

PA-2FE-TX and PA-2FE-FX Two-Port Fast Ethernet Port Adapter Installation and Configuration

4-8 OL-3474-07