Cisco Systems PA-2FE-TX Using the show version or show hardware Commands, page, 4-10, Function

Chapter 4 Configuring the PA-2FE

Checking the Configuration

Table 4-4	Using show Commands (continued)
Command		Function	Example
show interfaces type		Displays status information about a	Router# show interfaces fastethernet 1/0
slot-number/interface-port-number		specific type of interface (for
Note For the Cisco 7206 router		example, fastethernet) on a
		Cisco 7200 series router,
shelves, the show interfaces
		Cisco 7200 VXR router,
command requires a shelf
		Cisco uBR7200 series router,
number in the format show
		Cisco 7201 router, Cisco 7301
interfaces type shelf
		router, or Cisco 7401ASR router
number/port adapter slot/port.
show interfaces type		Displays status information about a	Router# show interfaces fastethernet
interface-processor-		specific type of interface (for	3/1/0
slot-number/port-adapter-slot-number/		example, fastethernet) on a VIP in a
interface-port-number		Cisco 7500 series router
show interfaces type		Displays status information about a	Router# show interfaces fastethernet 3/0
module-number/interface-port-number		specific type of interface (for
		example, fastethernet) in a
		Cisco 7304 PCI port adapter carrier
		card in a Cisco 7304 router
show protocols		Displays protocols configured for	Router# show protocols
		the entire system and for specific
		interfaces
show running-config		Displays the running configuration	Router# show running-config
		file
show startup-config		Displays the configuration stored in	Router# show startup-config
		NVRAM

If an interface is shut down and you configured it as up, or if the displays indicate that the hardware is not functioning properly, ensure that the interface is properly connected and terminated. If you still have problems bringing up the interface, contact a service representative for assistance.

This section includes the following subsections:

•Using the show version or show hardware Commands, page 4-11

•Using the show diag Command, page 4-14

•Using the show interfaces Command, page 4-18

Choose the subsection appropriate for your system. Proceed to the “Using the ping Command to Verify Network Connectivity” section on page 4-21when you have finished using the show commands.

PA-2FE-TX and PA-2FE-FX Two-Port Fast Ethernet Port Adapter Installation and Configuration

4-10 OL-3474-07