Cisco Systems PA-2FE-TX, PA-2FE-FX manual Using the show diag Command, 4-14

Chapter 4 Configuring the PA-2FE

Checking the Configuration

Router uptime is 5 minutes

System returned to ROM by reload

System image file is "tftp://172.168.0.0"

cisco RSP4 (R5000) processor with 65536K/2072K bytes of memory. R5000 CPU at 200Mhz, Implementation 35, Rev 2.1, 512KB L2 Cache Last reset from power-on

G.703/E1 software, Version 1.0. G.703/JT2 software, Version 1.0.

X.25 software, Version 3.0.0.

SuperLAT software (copyright 1990 by Meridian Technology Corp). Bridging software.

TN3270 Emulation software. Chassis Interface.

1 EIP controller (6 Ethernet).

1 VIP2 controller (2 FastEthernet).

1 VIP2 R5K controller (2 FastEthernet).

6 Ethernet/IEEE 802.3 interface(s)

4 FastEthernet/IEEE 802.3 interface(s)

123K bytes of non-volatile configuration memory.

8192K bytes of Flash PCMCIA card at slot 0 (Sector size 128K). 20480K bytes of Flash PCMCIA card at slot 1 (Sector size 128K). 8192K bytes of Flash internal SIMM (Sector size 256K).

No slave installed in slot 7. Configuration register is 0x100

Using the show diag Command

Display the types of port adapters installed in your system (and specific information about each) using the show diag slot command, where slot is the port adapter slot in a Cisco 7100 series router, Cisco 7200 series router, Cisco 7200 VXR router, Cisco uBR7200 series router, Cisco 7201 router, Cisco 7301 router, or Cisco 7401ASR router, the module slot in a Cisco 7304 PCI Port Adapter Carrier Card in a Cisco 7304 router, and the interface processor slot in a Cisco 7500 series router with a VIP.

Note The outputs that appear in this document may not match the output you receive when running these commands. The outputs in this document are examples only.

The following sections provide platform-specific output examples using the show diag command:

•Cisco 7100 Series Routers—Example Output of the show diag Command, page 4-15

•Cisco 7200 Series Routers and Cisco 7200 VXR Routers—Example Output of the show diag Command, page 4-15

•Cisco 7201 Router—Example Output of the show diag Command, page 4-16

•Cisco 7401ASR Routers—Example Output of the show diag Command, page 4-17

•VIP in Cisco 7500 Series Routers—Example Output of the show diag Command, page 4-17

PA-2FE-TX and PA-2FE-FX Two-Port Fast Ethernet Port Adapter Installation and Configuration

4-14 OL-3474-07