Using the EXEC Command Interpreter
Using the EXEC Command Interpreter
You modify the configuration of your router through the software command interpreter called the EXEC. You must enter the privileged level of the EXEC command interpreter (also called enable mode) with the enable command before you can use the configure command to configure a new interface or to change the existing configuration of an interface. The system prompts you for a password if one has been set.
The system prompt for the privileged level ends with a pound sign (#) instead of an angle bracket
(>). At the console terminal, use the following procedure to enter the privileged level:
Step 1 At the
Router> enable
Password:
Step 2 Enter the password (the password is case sensitive). For security purposes, the password is not displayed.
When you enter the correct password, the system displays the
Router#
If you installed a new
Identifying Chassis Slot, Port Adapter Slot, and
The following section describes how to identify the chassis slot, port adapter slot, and
Cisco 7200 Series and Cisco uBR7200 Series Ports
Physical port addresses specify the actual physical location of each interface port on the router. On Cisco 7200 series routers and Cisco uBR7200 series universal broadband routers, this address is composed of two parts in the format port adapter slot number/interface port number, as follows:
•The first number identifies the slot in which the
•The second number identifies the interface port on the