Cisco Systems PA-FE-FX, PA-FE-TX Removing a Port Adapter, Position-Cisco uBR7246, H11518, 16217

Removing a Port Adapter

Figure 5-3 Placing the Port Adapter Retention Clip in the Unlocked

Position—Cisco uBR7246

Port adapters

H11518

Port adapter retention clip in unlocked position

—For a Cisco uBR7223, place the port adapter lever in the unlocked position. (See Figure 5-4.)

Figure 5-4 Placing the Port Adapter Lever in the Unlocked Position—Cisco uBR7223

Port adapters

Port adapter lever in unlocked position

16217

Step 3 Grasp the handle on the port adapter and pull the port adapter from the router midplane, about halfway out of its slot. If you are removing a blank port adapter, pull the blank port adapter completely out of the chassis slot.

Note As you disengage the port adapter from the router midplane, OIR administratively shuts down all active interfaces on the port adapter.

Step 4 With the port adapter halfway out of the slot, disconnect all cables from the port adapter.

Step 5 After disconnecting the cables, pull the port adapter from its chassis slot.

Cisco uBR7200 Series and the PA-FE Port Adapters 5-3