cisco 7200 (R4700) processor with 22528K/10240K bytes of memory. R4700 processor, Implementation 33, Revision 1.0 (Level 2 Cache) Last reset from
Bridging software.
X.25 software, Version 2.0, NET2, BFE and GOSIP compliant. Chassis Interface.
4 Ethernet/IEEE 802.3 interfaces.
2 FastEthernet/IEEE 802.3 interfaces.
125K bytes of
20480K bytes of Flash PCMCIA card at slot 0 (Sector size 128K). 8192K bytes of Flash internal SIMM (Sector size 256K). Configuration register is 0x2
Use the show diag slot command to determine which type of port adapter is installed in your system. Specific port adapter information is displayed, as shown in the following example of a
Router# show diag 2 |
|
| |
Slot 2: |
|
|
|
| |||
Port adapter is analyzed |
|
| |
Port adapter insertion time 2d09h ago |
| ||
Hardware revision | 255.255 Board revision A0 |
| |
Serial number | 4294967295 | Part number | |
Test history | 0x0 | RMA number |
EEPROM format version 1 EEPROM contents (hex):
0x20: 01 02 01 01 FF FF FF FF 49 06 14 04 00 00 00 00
0x30: 50 00 00 00 FF FF FF FF FF FF FF FF FF FF FF FF
Proceed to the “Using the ping Command” section on page
Configuring