Cisco Systems SG50028PK9NA Policy Binding

Quality of Service
QoS Advanced Mode
Cisco Small Business 200, 300 and 500 Series Managed Switch Administration Guide (Internal Version) 518
25
If Police Type is Single, enter the following QoS parameters:
•Ingress Committed Information Rate (CIR)—Enter the CIR in Kbps. See a
description of this in the Bandwidth page.
•Ingress Committed Burst Size (CBS)—Enter the CBS in bytes. See a
description of this in the Bandwidth page.
•Exceed Action—Select the action assigned to incoming packets exceeding
the CIR. The options are:
-None—No action.
-Drop—Packets exceeding the defined CIR value are dropped.
-Out of Profile DSCP—IP packets exceeding the defined CIR are
forwarding with a new DSCP derived from the Out Of Profile DSCP
Mapping Table.
STEP 5 Click Apply.
Policy Binding
The Policy Binding page shows which policy profile is bound and to which port.
When a policy profile is bound to a specific port, it is active on that port. Only one
policy profile can be configured on a single port, but a single policy can be bound
to more than one port.
When a policy is bound to a port, it filters and applies QoS to ingress traffic that
belongs to the flows defined in the policy. The policy does not apply to traffic
egress to the same port.
To edit a policy, it must first be removed (unbound) from all those ports to which it
is bound.
NOTE It is possible to either bind a port to a policy or to an ACL but both cannot be bound.
To define policy binding:
STEP 1 Click Quality of Service > QoS Advanced Mode > Policy Binding.
STEP 2 Select a Policy Name and Interface Type if required.
STEP 3 Click Go. The policy is selected.
STEP 4 Select the following for the policy/interface: