Administration: Stack Management
Stack Ports
Cisco Small Business 200, 300 and 500 Series Managed Switch Administration Guide (Internal Version) 77
5

Auto Selection of Port Speed

You can set the stacking cable type to be discovered automatically when the
cable is connected to the port (auto-discovery is the default setting). The system
automatically identifies the stack cable type and selects the highest speed
supported by the cable and the port.
A SYSLOG message (informational level) requesting that the user configures the
port speed manually is displayed when the cable type is not recognized.

Connecting Units

Two units can only be connected in a stack if the ports on both ends of the link are
of the same speed. This is done by configuring the stack ports speed to:
Auto Speed mode
Same speed on each side of the connection
Cables Types
Each type of stack port can be used with specific cable types.
When the stack mode is set to Native Stacking, you can use either a fiber or
copper cable as a stacking cable. If both cables (Fiber and Copper) are
connected, fiber is the preferred media. Dual connection can be used for
redundancy. When a media change occurs, for example you disconnect the fiber
stacking cable and the copper stacking cable becomes active, the system initiates
a topology change event.
SG500X/
ESW2-550X
S1-S2 -XG 10 G/1G Yes
SG500X/
ESW2-550X
S1-S2 -5G 5 G/1G Yes
SG500XG Any pair of ports
from XG1 - XG16
1G or 10G Yes
Device Type Port Pair Possible Speeds in
Stack
Auto Speed
Selection
Availab le