Chapter2 Installing the SN 5428-2 Storage Router
Installing the SN 5428-2 Chassis
2-8
Cisco SN 5428-2 Storage Router Hardware Installation Guide
OL-4797-01
Figure2 Rack Rails
Note If your mounting-post holes cannot accommodate the rack-post screws or
clips shipped with your storage router, you will need to supply other
screws or clips suitable for your equipment rack.
To install the storage router in a rack, follow these steps:
Step2 Prepare for installation as follows:
a. Measure the depth of the rack from the outside of the front mounting posts to
the outside of the rear mounting rails. The depth must be at least 23.5 inches
(59.7 cm) but not more than 34inches (86.36 cm).
b. Measure the space between the inner edges of the left-front and right-front
mounting posts to ensure that the space for the chassis is at least 17.72inches
(45 cm) wide.
Step3 Remove two screws from the right side and two screws from the left side of the
chassis. (See Figure 2-3.)
85499
Front
Rear