Chapter2 Installing the SN 5428-2 Storage Router
Verifying Installation
2-30
Cisco SN 5428-2 Storage Router Hardware Installation Guide
OL-4797-01
Verifying Installation
Verifying installation of the SN5428-2 Stora ge Router consists of making sure
that it starts up properly and that the network and Fibre Channel connections are
operational.
Caution Fibre Channel ports should not be connected to zoned fabric until the SN5428-2
Domain ID has been configured. See the “Connecting to a Fibre Channel Port”
section on page 2-25. For information about configuring the Domain ID, see the
Cisco SN 5428-2 Storage Router Software Configuration Guide.

Verifying Start-up Operations

To verify that the storage router starts up properly, perform the following steps:
Step1 At the rear of the storage router, press the power switch to the on position.
Step2 At the front of the storage router, observe the POWER LED to make sure power
is on. Make sure that the FAULT LED is off.
Step3 Listen and check for air flow to make sure the fan assembly is operating.
Step4 Observe console output to make sure that the storage router software is booting
properly. The boot process may last for three to five minutes and will display boot
information and a banner. A successful boot-up is indicated by a CLI prompt for
user input.
Step5 If any of these conditions are not met, see Chapter3, “Troubleshooting,” to isolate
and, if possible, resolve the problem.