Cisco Systems SPA2102, SPA3102, WRP400, SPA8000, PAP2T manual Without Authentication

Configuring the PSTN (FXO) Gateway on the SPA3102	6
Call Scenarios

Without Authentication

This scenario can also be implemented without authentication, using one-stage or two-stage dialing, as in the HTTP Authentication case. The default VoIP caller dial plan is used in this scenario. Authentication is performed when the method is none or when the source IP address of the inbound INVITE matches one of the VoIP Access List patterns.

The following table lists the parameters used in VoIP to PSTN Call With and

Without Authentication.

Parameter	Web	Description	Value
	Page
VoIP	PSTN	Delay in seconds before auto-answering	The range is 0-
Answer	Line	inbound VoIP calls for the FXO account.	255. The
Delay			default is 3.
Outside Dial	Regional	Alternative to the Dial Tone. It prompts	The default is
Tone		the user to enter an external phone	420@-19;10(*/
		number, as opposed to an internal	0/1).
		extension. It is triggered by a comma
		encountered in the dial plan.
VoIP Caller	PSTN	A comma-separated list of caller	For example:
ID Pattern	Line	number templates such that callers	1408*,
		with numbers not matching any of	1512???1234.
		these templates are rejected for	NOTE: ‘?’
		PSTN gateway service regardless of
			matches any
		the setting of the authentication
			single digit; ‘*’
		method. The comparison is applied
			matches any
		before the access list is applied. If
			number of
		this parameter is blank (not
			digits.
		specified), all callers are considered
		for PSTN gateway service.	The default is
			blank.
VoIP	PSTN	A comma-separated list of IP address	For example:
Access List	Line	templates, such that callers with a	192.168.*.*,
		source IP address matching any of	66.43.12.1??.
		the templates are accepted for PSTN	The default is
		gateway service without further
			blank.
		authentication.

ATA Administration Guide 108