IP Configuration
Domain Name
301 Cisco Small Business 300 Series Managed Switch Administration Guide
16
•Type—Is this a Dynamic or Static entry to the cache.
•Status— Displays the results of attempts to access the host
-
OK—Attempt succeeded.
-
Negative Cache—Attempt failed, do not try again.
-
No Response—There was no response, but system can try again in
future.
•TTL— If this is a dynamic entry, how long will it remain in the cache.
•Remaining TTL— If this is a dynamic entry, how much longer will it remain in
the cache.
STEP 3 To add a host mapping, click Add.
STEP 4 Enter the pa rameters.
•IP Version—Select Version 6 for IP v6 or Vers ion 4 for IPv4.
•IPv6 Address Type—Select the IPv6 address type (if IP v6 is used). The
options are:
-Link Local—The IPv6 address uniquely identifies hosts on a single
network link. A link local address has a prefix of FE80, is not routable, and
can be used for communication only on the local network. Only one link
local address is supported. If a link local address exists on the interface,
this entry replaces the address in the configuration.
-Global—The IPv6 address is a global Unicast IPV6 type that is visible and
reachable from other networks.
•Link Local Interface—If the IPv6 address type is Link Local, select the
interface through which it is received.
•Host Name—Enter a user-defined host name or fully-qualified name. Host
names are restricted to the ASCII letters A through Z (case-insensitive), the
digits 0 through 9, the underscore and the hyphen. A period (.) is used to
separate labels.
•IP Address(es)—Enter a single address or up to eight associated IP
addresses (IPv4 or IPv6).