SNMP
Notification Recipients
Cisco Small Business 300 Series Managed Switch Administration Guide 462
23
To define a recipient in SNMPv3:
STEP 1 Click SNMP > Notification Recipients SNMPv3.
This page contains recipients for SNMPv3.
STEP 2 Click Add.
STEP 3 Enter the parameters.
•Server Definition—Select whether to specify the remote log server by IP
address or name.
•IP Version—Select either IPv4 or IPv6.
•IPv6 Address Type—Select the IPv6 address type (if IP v6 is used). The
options are:
-Link Local—The IPv6 address uniquely identifies hosts on a single
network link. A link local address has a prefix of FE80, is not routable, and
can be used for communication only on the local network. Only one link
local address is supported. If a link local address exists on the interface,
this entry replaces the address in the configuration.
-Global—The IPv6 address is a global Unicast IPV6 type that is visible and
reachable from other networks.
•Link Local Interface—Select the link local interface (if IPv6 Address Type
Link Local is selected) from the pull-down list.
•Recipient IP Address/Name—Enter the IP address or server name of
where the traps are sent.
•UDP Port—Enter the UDP port used to for notifications on the recipient
device.
•Notification Type—Select whether to send traps or informs. If both are
required, two recipients must be created.
•Time out—Enter the amount of time (seconds) the device waits before re-
sending informs/traps. Timeout: Range 1-300, default 15
•Retries—Enter the number of times that the device resends an inform
request. Retries: Range 1-255, default 3