Versatile Interface Processor Functions
Step 5 Remove a SIMM by pulling outward on the connectors to unlatch it, as shown in the enlargement in Figure 12. Be careful not to break the holders on the SIMM connector.
Figure 12 Removing and Replacing DRAM SIMMs
Faceplate edge of the system card
Pull the tabs away with your thumbs, bracing your forefingers against the posts. Raise the SIMM to a vertical position.
Polarization notch
DRAM SIMM
H2017
Step 6 Using the SIMM orientation shown in Figure 12, position the new SIMM so that the polarization notch is located at the right end of the SIMM socket.
Step 7 Insert the new SIMM by sliding the end with the metal fingers into the SIMM connector socket at approximately a
Caution Do not use excessive force, or the connector could break. To prevent damage, do not push on the center of the SIMMs. Handle each SIMM with care.
Step 8 As required, repeat Steps 5 through 7 for the second SIMM.
Step 9 Reinstall the VIP in the chassis using the procedure in the section “Installing a VIP” on page 18.
If error messages relating to memory are displayed once power to the chassis is turned back on, or the VIP card is installed in a chassis that is already on, repeat Steps 1 through 8, taking care to firmly reseat each SIMM in its socket.
This completes the procedure for upgrading or replacing DRAM SIMMs on your VIP.
28
