5.3Jumper Wire Function
The jumper wires have been set at shipment. The following lists the basic settings at shipment. Check the settings by performing
Jumper Wires
No. | Function | Short | Open | Upon | |
Shipment | |||||
|
|
|
| ||
J1 |
|
|
| Short | |
J2 | International character | See Table 3 | Short | ||
J3 |
|
|
| Short | |
J4 | Data bit length | 7 bits | 8 bits | Open | |
J5 | Unused | - | - | Open | |
J6 | Label detection | Black mark | Label interval | Open | |
J7 | Unused | - | - | Open | |
J8 | Communication error mark | Ignored | "?" printed | Open | |
*J4: Serial interface only. Disabled for the parallel one.
*J5~J7: Do not change the shipment settings.
Table 3
No. | USA | France | Germany | U.K. | Sweden | Italy | Japan | |
J1 | Short | Open | Short | Open | Short | Open | Short | Open |
J2 | Short | Short | Open | Open | Short | Short | Open | Open |
J3 | Short | Short | Short | Short | Open | Open | Open | Open |
CAUTION:
1)Never change the settings of the jumper wires.
2)If you want to change their settings, consult us.
3)Never disassemble the printer body. It could cause trouble, etc.
33 | CITIZEN |
