![](/images/new-backgrounds/1263696/263696133x1.webp)
ESC v |
|
|
| (Serial Interface Only) | |||
|
|
|
|
|
| ||
[Function] | Transmitting the printer status |
|
|
|
| ||
[Code] | <1B> H <76> H |
|
|
|
|
| |
[Outline] | Current printer status is transmitted.. |
|
|
|
| ||
[Caution] | · Status sent out consists of 1 byte whose content is as in the table below. | ||||||
| · In DTR/DSR control, after receptible state of the host (DSR signal being in | ||||||
| SPACE state) is confirmed, only 1 byte is transmitted. In XON/XOFF control, | ||||||
| DSR signal state not being confirmed, only 1 byte is transmitted. | ||||||
| · In DTR/DSR control, when the host is in unreceptible state(DSR signal being | ||||||
| in MARK state), it waits until receptible state is created. | ||||||
| · In paper end (paper near end) status, this command may be unreceptible state | ||||||
| due to BUSY state. |
|
|
|
|
| |
| Remarks. This command is valid only for serial interface model. | ||||||
|
|
|
|
|
| ||
| Bit | Function | Value |
|
| ||
| 0 |
| 1 |
|
| ||
|
|
|
|
|
| ||
| 0 | Not defined |
|
|
|
|
|
| 1 | Not defined |
|
|
|
|
|
| 2 | Paper end | With paper |
| Without paper |
|
|
| 3 | Not defined |
|
|
|
|
|
| 4 | Not used | Fixed to 0 |
| - |
|
|
| 5 | Not defined |
|
|
|
|
|
| 6 | Not defined |
|
|
|
|
|
| 7 | Not defined |
|
|
|
|
|
[Sample Program] |
|
|
|
|
|
|
OPEN "COM1:N81NN" AS #1 ;
PRINT #1, CHR$ (&H1B) ; "v" ;
A$ = INPUT$ (1, #1) ;
CLOSE #1
END
67 | CITIZEN |