top correction amount is specified that will exceed the top edge of the label, the position will be set as the top edge of the label.
•It will not be possible to set the length that can be printed on one label to a value of less than 2/6 inch. In a situation where the setting is less than 2/6 inch, the setting will become 2/6 inch.
•The initial value of the label top position will be approximately 1.5 mm from the label top edge position.
•This command will only be effective when the label printing has been set.
•This command will be only be effective immediately after moving to the top of the label. (After paper feeding using the FF, GS, FF, GS <commands or LF switch, or after switching the power on.)
•Due to the flexing and the range of differences in the paper, the moving to the top of the label may have a ±1 mm shift in position. Adequate consideration should be taken of this fact when carrying out the setting.
[Initial value] | l.5 mm |
[Reference] | FF, GS FF |
[Program example]
LPRINT CHR$(&H1D) + "A" ;
LPRINT CHR$(0) + CHR$(0) ;
LPRINT "AAAAA" + CHR$(&HC) ;
LPRINT CHR$(&H1D) + "A" ;
LPRINT CHR$(1) + CHR$(8) ;
LPRINT "AAAAA" + CHR$(&HC) ;
LPRINT CHR$(&H1D) + "A" ;
LPRINT CHR$ (0) + CHR$ (20) ;
LPRINT "AAAAA" + CHR$(&H) ;
103 | CITIZEN |
