6. REMOVING THE MAIN UNIT

English

1.After the rear of the main unit has been secured by the method shown in Figure 6 unfasten the special screw.

2.Remove the outer escutcheon.

3.Insert the hook plate between the spring and the universal mounting bracket, fit tab B of the spring into hole A of the hook plate, then

Universal mounting bracket

2-Hook plate

pull the main unit out by the hook plate. (Insert both the right and left edges of the hook plate.) (Figure 9)

Note: Do not dispose of the hook plate. You cannot remove the main unit without disengaging the hook plate.

Instrument panel

Main

Unit

Spring

Outer escutcheon

AB

Figure 9

7. CAUTIONS ON WIRING

1.Be sure to turn the power off before wiring.

2.Be particularly careful where you route the wires.

Keep them well away from the engine, and exhaust pipe, etc. Heat may damage the wires.

Note: There are various types of fuse holders. Do not let the battery side touch other metal parts.

CAUTION

After connecting, secure the lead with a clamp or insulation tape for protection.

3. If the fuse should blow, check to see if the wiring is correct.

If it is correct, replace the fuse with a new

Fuse (15A FUSE)

one with the same amperage rating as the

original (15A FUSE).

4. To replace the fuse, remove the old fuse of

the power supply lead and insert the newFuse holder one. (Figure10)

Figure 10

TB851P/TB853W 25