5. OPERATION
Basic Operation | Note: Be sure to read this chapter referring to the front diagrams in |
chapter “3. CONTROLS” on page 5 (unfold). |
English
Opening and adjusting the LCD panel
WARNING
•To prevent the battery from going dead, operate this unit with the engine running if possible.
•When the LCD panel is operating, be careful not to get your hands or finger caught between the panel and main unit or the vehicle instrument panel.
•Do not move the LCD panel by hand.Raising the LCD panel
Panel calibration function
The LCD panel’s maximum angle of tilt can be adjusted to match the installation configuration within the automobile.
• Perform this with the LCD panel closed.
1.Press and hold the [OPEN] button for 5 seconds or longer, until the electronic beep is heard.
2.The beep will sound twice, the panel will rise and the calibration function will begin.
3.After completion of calibration, the panel will close automatically.
∗If the panel does not strike the instrument panel or other parts of the car during calibration, then the maximum tilt is 110°.
1.Press the [OPEN] button. The LCD panel then ejects and rises automatically.
∗While the LCD panel is opening or closing, the blue LED of the [OPEN] button will flash.
Notes:
•If the LCD panel stops in the middle of this operation, press the [OPEN] button to house the panel and then press the button again to stand it up. The unit will be in the same display mode as when last turned off.
∗If the panel comes in contact or strikes a car part during calibration in a range of 70° then the maximum downward tilt is 70°.
Adjusting the angle, etc. of the LCD panel
The angle of the LCD panel or amount the panel protrudes from the mounting surface can be adjusted depending on the mounting angle of the unit or light coming into the vehicle.
●To adjust the angle1.Every time the [TILT] button is pressed, the LCD panel tilts forward or backward at up to about 20 degrees. The adjusted angel is stored in the memory.
Note:
• Do not move the LCD panel by hand.
TB851P/TB853W 9