![9. IN CASE OF DIFFICULTY](/images/new-backgrounds/187221/18722139x1.webp)
DSP operations
∗By pressing the PRESET buttons # 1 to 6 for 2 seconds or longer in the P.EQ adjusting dis- play, the P.EQ pattern can be stored in the USER memory.
7.To set a title of the stored USER pattern, op- erate the JOYSTICK ¡ rightward or leftward to select “TITLE” and press the ENT at the center of the JOYSTICK ¡to change into the Title Input display.
∗For title inputting method, refer to the section “Entering titles”.
8.Operate the JOYSTICK ¡ rightward or left- ward to select “MENU” and press the ENT at the center of the JOYSTICK ¡to change into the
9. IN CASE OF DIFFICULTY
| Problem | Cause | Measure | ||||
| Power does not | Fuse is blown. | Replace with a fuse of the same amperage. If the | ||||
| turn on. |
| fuse blows again, consult your store of purchase. | ||||
| (No sound is |
|
|
|
|
|
|
| Consult your store of purchase. | ||||||
| produced.) | Incorrect wiring. | |||||
|
|
|
|
|
|
|
|
| Nothing happens | The microprocessor has | Turn off the power, then press the RELEASE lever | ||||
| when buttons are | malfunctioned due to noise, | 6 and remove the DCP. | ||||
| pressed. | etc. | Press the RESET button for about 2 seconds with | ||||
|
|
| a thin rod. | ||||
| Display is not |
|
|
|
|
|
|
| accurate. |
|
|
|
|
|
|
|
|
|
|
|
|
|
|
GENERAL |
|
|
| |
|
| DCP or main unit connectors | Wipe the dirt off with a soft cloth moistened with |
|
|
| are dirty. | cleaning alcohol. |
|
|
|
|
|
|
| The remote | The display is not open. | The remote controller does not work unless the |
|
| controller does |
| display is open. |
|
| not work. |
|
|
|
| Direct rays of the sun fall on | When direct rays of the sun fall on the light- |
| |
|
|
| ||
|
| the | receptive part of the remote controller, it may not |
|
|
| remote controller. | work. |
|
|
|
|
|
|
|
| The batteries of the remote | Check the batteries of the remote controller unit. |
|
|
| controller unit are dead or |
|
|
|
| there is no battery in the |
|
|
|
| remote controller unit. |
|
|
|
|
|
|
|
| The image is not | The parking brake is not | Check that the parking brake is applied. |
|
| displayed. | pulled. |
|
|
|
|
|
|
|
| The display is | The brightness control is too | Adjust the brightness properly. |
|
| dark. | low. |
|
|
|
|
|
|
|
|
| The operating condition is | The temperature inside the vehicle may be 0˚C or |
|
|
| not good. | less. Set to an appropriate temperature (25˚C or |
|
|
|
| so) and check it again. |
|
|
|
|
|
|
|
| The headlight of the vehicle | The display is made dark at night to prevent the |
|
TV | is lit. | glare (When the headlight of the vehicle is lit in the |
| |
| daytime, the display gets dark). |
| ||
|
|
|
| |
|
|
|
|
|
| The color of the | The color is not adjusted | Check that COL and HUE are adjusted properly. |
|
| display is light or | adequately. |
|
|
| a shade of color |
|
|
|
| is not good. |
|
|
|
|
|
|
|
|
| When the VTR is | Improper NTSC/PAL setting | Set the NTSC/PAL properly according to the VTR. |
|
| connected, the |
|
|
|
| image is |
|
|
|
| disturbed. |
|
|
|
38 | VRX610 | VRX610 | 39 |