Clarion VRX610 owner manual Wire Connection

7. CAUTIONS ON WIRING

8. WIRE CONNECTION

1.Be sure to turn the power off before wiring.

2.Be particularly careful where you route the wires.

Keep them well away from the engine, and exhaust pipe, etc. Heat may damage the wires.

3.If the fuse should blow, check to see if the wiring is correct.

If it is, replace the fuse with a new one with the same amperage rating as the original.

4.When any fuse is to be replaced, pull out the fuse (15A) at the rear of the main unit and put in a new one (Fig.10).

CAUTION

After the connection, fix the lead by a clamp or insulation tape for protection.

5.When connecting the ground lead, fasten the ground lead (black) securely to a clean metal plate on the car. (Figure 11)

If the set is insufficiently grounded, it may not operate or there may be noise.

AUDIO 4CH. OUTPUT terminal

Gray Red

Front right

Gray White

Front left

Brack Red

Rear right

White

Brack

Rear left

Figure 10

∗1: Connect securely to the metal part of the vehicle with a screw, etc.

∗2: Connect to the power supply terminal which can be turned on and off by the ignition switch.

∗3: Connect to the power supply terminal where the power is always supplied regardless of whether the ignition switch is turned on or off.

∗4: Connect to the remote turn-on lead of amplifiers.

∗5: Use the attached extension lead when necessary.

∗6: Connect the terminal to the lead wire on the lamp side of the parking brake lamp switch. After connection, apply the parking brake, then check that the TV displays an image.

• If the PKB lead is not connected to the side brake, some units may not operate.

48 VRX610 VRX610 49