6. DCP
The control panel can be detached to prevent theft. When detaching the control panel, store it in the DCP (DETACHABLE CONTROL PANEL) case to prevent scratches.
2.Lock the DCP/Operation Panel at the upper center until a click is heard.
POWER button
7. CAUTIONS ON HANDLING
LCD panel/Generalities
For a longer service life, be sure to read the following cautions.
We recommend taking the DCP with you when leaving the car.
Removing the DCP
1.Turn the power off.
2.Deeply push in the DCP RELEASE lever 6 to release the DCP/Operation Panel.
DCP/RALEASE lever
3. Pull the DCP toward you and remove it.
3.Press the power button 1 to turn on the power .
∗The unit will not accept any key inputs for 1 second after the DCP has been reattached.
CAUTION
• The DCP can easily be damaged by shocks. |
After removing it, be careful not to drop it |
or subject it to strong shocks. |
• If the Operation Panel is kept open, the DCP |
may drop due to vibration of the car. This |
results in damage to the DCP. So close the |
•Be sure to store the LCD panel inside the main unit when parking the car outdoors for long period of time. The LCD panel will oper-
ate properly in a temperature range of 0 to 60° C.
•Don’t allow any liquids on the set from drinks, umbrellas etc. Doing so may damage the in- ternal circuitry.
•Do not disassemble or modify the set in any way. Doing so may result in damage.
•Do not draw the LCD panel out and use it as a tray. Also, subjecting the LCD panel to shocks may result in breakage, deformation or other damage.
•Do not let cigarettes burn the display. Doing so may damage or deform the cabinet.
•If a problem should occur, have the set in- spected at your store of purchase.
•Do not insert objects or poke in the space be- tween the LCD panel and the main unit when the panel is tilted.
•Do not place anything on the display when the panel is tilted.
•The remote controller may not work if the re- mote control sensor is exposed to direct sun- light.
•In extremely cold weather, the display move- ment may slow down and the display may darken, but this is not a malfunction. The dis- play will work normally when the temperature increases.
•Small black and shiny spots inside the LCD panel are normal for LCD products.
•The LCD panel may stop temporarily when it opens or closes, when the engine stops or when it is cold.
Operation Panel or remove the DCP to store |
into the case. |
Cleaning
DCP/Operation Panel
Attaching the DCP
1.Hold the DCP/Operation Panel with its rear side facing the main unit and, as shown in the figure below, put the lower edge of the panel onto the corresponding edge of the main unit.
• The connector connecting the main unit and |
the DCP is an extremely important part. Be |
careful not to damage it by pressing on it |
with fingernails, screwdrivers, etc. |
Note:
•If the DCP is dirty, wipe off the dirt with a soft, dry cloth only.
•Cleaning the cabinet
Use a soft, dry cloth and gently wipe off the dirt. For tough dirt, apply some neutral detergent diluted in water to a soft cloth, wipe off the dirt gently, then wipe again with a dry cloth.
Do not use benzene, thinner, car cleaner, etc., as these substances may damage the cabinet or cause the paint to peel. Also, leaving rubber or plastic products in contact with the cabinet for long periods of time may cause stains.
•Cleaning the LCD panel
The LCD panel tends to collect dust, so wipe it off occasionally with a soft cloth. The surface is easily scratched, so do not rub it with hard ob- jects.
14 | VRX610 | VRX610 | 15 |
