6. REMOTE CONTROL

2. PRECAUTIONS

Handling Compact Discs

Use only compact discs bearing the mark.

1. When the inside of the car is very cold and

the player is used soon after switching on

3. When the auto antenna cord is connected to

the car auto antenna cord, when the unit is

Do not play heart-shaped, octagonal, or other specially shaped compact discs.

Receiver for remote control unit

Operating range: 30° in all directions

Signal transmitter

Remote control unit

the heater moisture may form on the disc or

the optical parts of the player and proper

playback may not be possible. If moisture

forms on the disc, wipe it off with a soft cloth.

If moisture forms on the optical parts of the

player, do not use the player for about one

hour. The condensation will disappear natu-

rally allowing normal operation.

2. Driving on extremely bumpy roads which

cause severe vibration may cause the sound

to skip.

switched to the radio mode (or the TV mode),

the antenna is extended automatically. If the

car is in a narrow space, the antenna may

strike something, so be careful.

4. This unit uses a precision mechanism. Even

in the event that trouble arises, never open

the case, disassemble the unit, or lubricate

the rotating parts.

Handling

New discs may have some roughness around the edges. If such discs are used, the player may not work or the sound may skip. Use a ball-point pen or the like to remove any rough- ness from the edge of the disc.

Ball-point pen

Roughness

To remove a compact disc from its storage case, press down on the center of the case and lift the disc out, holding it carefully by the edges.

Do not use commercially available CD protec- tion sheets or discs equipped with stabilizers, etc. These may damage the disc or cause breakdown of the internal mechanism.

Storage

• Do not expose compact discs to direct sun-

light or any heat source.

This equipment has been tested and found to comply with the limits for a Class B digital de- vice, pursuant to Part 15 of the FCC Rules.

These limits are designed to provide reason- able protection against harmful interference in a residential installation.

This equipment generates, uses, and can radi- ate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio com- munications. However, there is no guarantee that interference will not occur in a particular installation.

CAUTION

USE OF CONTROLS, ADJUSTMENTS, OR PERFORMANCE OF PROCEDURES OTHER THAN THOSE SPECIFIED HEREIN, MAY RE- SULT IN HAZARDOUS RADIATION EXPO- SURE.

THE COMPACT DISC PLAYER and MINI DISC PLAYER SHOULD NOT BE ADJUSTED OR REPAIRED BY ANYONE EXCEPT PROPERLY QUALIFIED SERVICE PERSONNEL.

CHANGES OR MODIFICATIONS NOT EX- PRESSLY APPROVED BY THE MANUFAC- TURER FOR COMPLIANCE COULD VOID

Never stick labels on the surface of the compact disc or mark the surface with a pencil or pen.

Never play a compact disc with any cellophane tape or other glue on it or with peeling off marks. If you try to play such a compact disc, you may not be able to get it back out of the CD player or it may damage the CD player.

Do not use compact discs that have large scratches, are misshapen, cracked, etc. Use of such discs may cause misoperation or damage.

• Do not expose compact discs to excess hu-

midity or dust.

• Do not expose compact discs to direct heat

from heaters.

Cleaning

To remove fingermarks and dust, use a soft cloth and wipe in a straight line from the cen- ter of the compact disc to the circumference.

Do not use any solvents, such as commercially available cleaners, anti-static spray or thinner to clean compact discs.

After using special compact disc cleaner, let the compact disc dry off well before playing it.

If this equipment does cause harmful interfer- ence to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to consult the dealer or an experienced radio/TV technician for help.

THE USER’S AUTHORITY TO OPERATE THE EQUIPMENT.

INFORMATION FOR USERS:.

CHANGES OR MODIFICATIONS TO THIS PRODUCT NOT APPROVED BY THE MANU-

Sloping Console

When you use the sloping console, be sure to close it.

This unit uses sloping consoles to make large-screen displays possible.

Inserting the Batteries

FACTURER WILL VOID THE WARRANTY AND WILL VIOLATE FCC APPROVAL.

CAUTION

Be careful not to get your fingers caught when

3. If you move the SLOPING CONSOLE by

hand, this may create play. To correct this

play, with the power on for the unit, press

MODEL

opening and closing the SLOPING CONSOLE.

OPEN button 4 to close the SLOPING

1. Turn the remote control unit over, then slide the rear cover in the direction of the arrow.

2.Insert the AA (SUM-3, IECR-6/1.5V) batter- ies that came with the remote control unit

facing in the directions shown in the figure, then close the rear cover.

Notes:

 

Using batteries improperly can cause them to explode.

 

Take note of the following points:

 

• When replacing batteries, replace both batteries

Rear side

with new ones.

Do not short-circuit, disassemble or heat batteries.

Do not dispose of batteries into fire or flames.

AA (SUM-3, IECR-6/1.5V) Batteries

Rear cover

12V GROUND

AM 530-1710kHz/FM 87.9-107.9MHz

THIS DEVICE COMPLIES WITH PART 15 OF THE FCC RULES.

OPERATION IS SUBJECT TO THE FOLLOWING TWO CONDITIONS:

(1)THIS DEVICE MAY NOT CAUSE HARMFUL INTERFERENCE, AND

(2)THIS DEVICE MUST ACCEPT ANY INTERFERENCE RECEIVED, INCLUDING INTERFERENCE TAHT MAY CAUSE UNDESIRED OPERATION.

THIS PRODUCTION COMPLIES WITH DHHS RULES 21 CFR

SUBCHAPTER J APPLICABLE AT DATE OF MANUFACTURE.

CLARION CO.,LTD.

50 KAMITODA,TODA-SHI,SAITAMA-KEN,JAPAN

MANUFACTURED:

 

 

286-

 

 

 

 

SERIAL No.

Clarion Co.,Ltd.

PE-

 

MADE IN

 

Bottom View of Source Unit

 

 

 

 

1.For safety’s sake, always close the SLOP- ING CONSOLE before leaving this unit unused for a prolonged period or switching OFF the ignition key.

If you switch OFF the ignition key with the SLOPING CONSOLE tilted, the SLOPING CONSOLE does not close.

2.Before the SLOPING CONSOLE closes, there may be a braking sound from the safety mechanism. This is normal.

CONSOLE.

4. After a CD is ejected, the SLOPING CON-

SOLE automatically returns to the tilted or

closed state. If there is any obstruction when

the SLOPING CONSOLE tries to close, the

safety mechanism is triggered and the SLOP-

ING CONSOLE returns to the open state. If

this happens, remove the obstruction, then

press OPEN button 4.

5. To avoid scratching the compact disk, keep

the 12 or 8 cm CD level when inserting or

removing them.

• Dispose of spent batteries properly.

Be sure to unfold and read the next page. Veuillez dé plier et vous ré fé rer à la page suivante.

Cerció rese de desplegar y de leer la pá gina siguiente.

8

XDZ716

XDZ716

3

XDZ716

4

Page 3
Image 3
Clarion XDZ716 owner manual Handling, Storage, Cleaning

XDZ716 specifications

The Clarion XDZ716 is a high-performance multimedia head unit designed to enhance the in-car experience for audiophiles and casual listeners alike. This model is part of Clarion's commitment to providing advanced automotive audio solutions, blending cutting-edge technology with user-friendly features.

One of the standout characteristics of the XDZ716 is its robust sound processing capabilities. It boasts a built-in 24-bit DAC (Digital-to-Analog Converter) that ensures superior sound quality, delivering clear and accurate audio reproduction. Additionally, the unit features a 3-band equalizer, allowing users to customize their audio settings to suit their specific preferences and the acoustics of their vehicle.

Connectivity is at the forefront of the XDZ716's design, ensuring users can easily integrate their devices for a seamless listening experience. The unit supports both Bluetooth and USB connectivity, enabling hands-free calling and audio streaming from smartphones and other compatible devices. The Bluetooth feature is particularly noteworthy, as it allows for quick pairing and stable connections, making it easy to enjoy music or take calls on the go.

The XDZ716 also includes a built-in AM/FM tuner, providing access to a wide variety of radio stations for those who enjoy traditional broadcasting. The user interface is intuitive, featuring a bright LED display that provides clear visibility, ensuring that users can easily access their favorite functions even in low-light conditions.

Another significant feature of this head unit is its compatibility with various audio formats. The XDZ716 can play MP3, WMA, AAC, and WAV files, catering to a wide range of audio preferences and formats. Additionally, it supports iPod and iPhone connectivity through USB, making it a versatile choice for Apple users.

For those who value expandability, the Clarion XDZ716 includes multiple preamp outputs, which allow for the connection of external amplifiers and subwoofers. This means users can easily upgrade their audio system as their needs evolve, ensuring longevity and adaptability.

In summary, the Clarion XDZ716 is a feature-rich multimedia head unit designed for sound quality, connectivity, and expandability. With its advanced audio processing technologies, user-friendly interface, and comprehensive compatibility, it stands out as an excellent choice for anyone looking to enhance their driving experience with superior sound. Whether for daily commutes or longer road trips, the XDZ716 delivers on performance and versatility.