Installing and Using Your CLS45i
There are six (6) steps involved in setting up your CLS45i.
1.Install included battery pack into handset.
2.(Optional) Insert four AA alkaline batteries (for backup in case of AC power outage) into base.
3.Decide if you want the telephone to sit on a desk/tabletop or hang on the wall (if on the wall, follow Instructions for Wall Mounting)
4.Plug the telephone line cord into the phone base and telephone wall jack
5.Plug the electrical adapter into a
6.Place handset in the cradle face up and let charge overnight or for
Installing, Replacing and
Charging the Handset
Battery Pack
Note: the battery pack must be fully charged before using the
Remove the battery cover on the back of the handset by pushing the battery compartment “button” and sliding the cover towards the bottom of the handset.
1.To install the battery pack, plug the cord of the battery pack into the terminal in the battery compartment. Replace the battery cover by sliding it into place until it “clicks”.
2.To replace the battery pack, remove the
battery cover as stated above and unplug the battery from the battery compartment. Remove old battery pack. Install new battery pack and plug the cord of the battery pack into the terminal in the battery compartment.
Replace the battery cover by sliding it into place until it “clicks”.
Monitoring the Handset
Battery Level
The battery icon will show “full” if there is an adequate charge level on the battery. As the phone is used the battery will discharge. When the handset battery is low the display will show the battery icon in an “empty” state, the unit will “beep” every thirty (30) seconds, and the IN USE/NEW CALL light will flash. If you are using the phone, the phone will go dead after approximately two (2) min- utes. Place the handset back into the base to recharge the battery.
11
