Classe Audio cp-700 English, Pin 1 Signal ground, Pin 2 Signal + non-inverting, 4Tape output

The pin assignments of the XLR-type female input connectors are:

Pin 1: Signal ground

Pin 2: Signal + (non-inverting)

Pin 3: Signal – (inverting)

Connector ground lug: chassis ground

Refer to the operating manuals of your balanced-output line-level sources to verify that the pin assignments of their output connectors correspond to the CP-700. If not, wire the cables so that the appropriate output pin connects to the equivalent input pin.

To achieve the best possible results, we suggest that you use only high- quality interconnect cables. Please consult with your local Classé dealer for advice on the best cables for use in your system.

4Tape output

Connect these RCA jacks to the right-channel and left-channel recording inputs of your recorder.

These single-ended RCA outputs are unaffected by the volume control on the front panel, or by whether you choose to monitor the source or the recorder (by having the “tape” button on the front panel’s touchscreen deselected or selected, respectively). The record outputs will be disconnected when the preamplifier is placed into standby, however.

5Single-ended (RCA) main outputs

Single-ended cables using RCA connectors are the most common form of analog connection used in consumer electronics. When implemented carefully and used with high quality interconnect cables, this standard can provide excellent performance.

Classé has gone to extraordinary effort to ensure that the single-ended (RCA) outputs of your preamplifier are as good as possible. However, this connection standard cannot offer the immunity from interference that balanced interconnection does–hence our recommendation to use the balanced outputs whenever possible.

If you are not using balanced analog interconnection, then connect these single-ended outputs to your preamplifier using high-quality shielded RCA-terminated cables. Your Classé dealer can advise you on the selection of cables suitable for your system.

6Balanced (XLR) main outputs

The CP-700 supports two pairs of high quality XLR outputs to provide balanced stereo analog signal to your power amplifier(s). In most cases, you will connect one pair only to corresponding balanced inputs on your power amplifier, using shielded high-quality balanced interconnects. If you choose to biamplify your speakers, you may need to use both outputs. Your Classé dealer can provide assistance in selecting appropriate balanced cables for your system, as well as advice on the potential benefits of biamplification in your particular situation.

ENGLISH

15