Cleveland Range KCL-25-T Lubrication Procedure, Hinge Adjustment, Instructions, Trunnion, Housing

LUBRICATION PROCEDURE

Lubricate the following parts every three months to insure smooth operation and reduce wear.

	TRUNNION
Adjusting	HOUSING ,
Screw
	WORM SCREW
Worm	AND TILT GEAR
Screw and	These parts are
Tilt
	accessed through the
Gear
Cross	top cover of the
Bar	console.
	Apply grease to gear
	teeth. Check for

excessive play and adjust with adjusting screw located on top of cross bar.

HINGE ADJUSTMENT

INSTRUCTIONS 3/8" Allen wrench

1.	Insert 3/8" Allen wrench.
2.	Turn clockwise to relieve tension on spring.
3.	While tension is released remove one of the two
	slotted screws.
4.	To prevent Allen wrench from springing back
	abruptly while the second slotted screw is removed,
	insert a pin (approximately 1/8") in the hole where

Trunnion Housing

Grease Nipple

KETTLE

TRUNNIONS

On the left hand side of the kettle there are two grease nipples on the top back portion of the trunnion housing. On the right hand side of the kettle you must remove the console cover to access the grease nipple.

	the first slotted screw was removed from.
5.	Remove second slotted screw.
6.	While holding Allen wrench remove pin.
7.	Turn Allen wrench clockwise to tighten or
	counter-clockwise to loosen tension to produce
	desired effect.
8.	Re-insert pin in one of the two holes.
9.	Tighten one slotted screw in the other hole (it
	may be necessary to turn Allen wrench slightly to
	align holes).
10.	Remove pin and repeat step number 9. for other
	slotted screw.

22