CustomerAssistance WarrantyIntroduction
21
Operation
20
Operation
MemoryLocationScan •
YourmicroTALK®radio can automatically scan up to
10programmed Memory Locations.
Ifthere are one or fewer memory locations
programmedin your radio, the scan memory
locationsoption will not be available. To program
atleast two (2) memory locations, see program
memorylocations on page 13.
Toscan memory locations:
1.Press the Mode button until the Scan icon,
Memoryicon and the memory location
numberflash on the display.
2.Press the ChannelUp or ChannelDown
buttonto begin scanning memory locations.
TheScan icon and the Memory icon will
continueto be displayed when memory
locationscan is on. Your radio will continue
toscan memory locations and stop if an
incomingtransmission is detected. Your
radiowill remain on that memory location
for10 seconds.
Whilesetting memory location scan, if you
donot press any buttons for 15 seconds,
yourradio will automatically return to
Standbymode on the channel/privacy code
displayedbefore you entered mode functions.
Mode Functions
Duringprivacy code scan (while receiving an incoming
transmission),you can choose from the following:
a.Press and hold the Talkbutton to communicate on
thatchannel/privacy code. Your radio will remain on
thatchannel/privacy code and return to Standby mode.
b.Press the Channel Up or Channel Down button to
resumescanning privacy codes.
Ifyou press the Talkbutton while scanning, but more than
10seconds after receiving a transmission, you will transmit
onthe channel/privacy code on which you last received a
transmission.This will then return the radio to Standby mode.
Ifyou do not press any button within 10 seconds, your
radiowill automatically resume scanning privacy codes.
Duringprivacy code scan (while not receiving a transmission),
youcan choose from the following:
a.Press and hold the Talkbutton to communicate on
thechannel/privacy code that was displayed before you
enteredmode functions or the channel/privacy code on
which,during scanning, you last received a transmission.
Thiswill return the radio to Standby mode.
b.Press the Mode button to proceed to set memory location
scan(see page 21 for further details).
c.Press the Lock/Enter button to return to Standby
modeon the channel/privacy code that was displayed
beforeyou entered mode functions or the channel/
privacycode on which, during scanning, you last
receiveda transmission.
ChannelButtons
ScanningLocations
ModeButton