Combi 8040 instruction manual Fig. f

8040 (EN) 122904.qxd 12/29/04 9:17 PM Page 25

10Connect lower anchor connectors to vehicle lower anchors:

-Position red release button of push-on connector facing away from base and wording on back side of connector facing base. If connector is not in this position, turn connector over.

- Position the slot of the push-on connector over the vehicle anchorage. Push connector in to lock onto the vehicle anchorage (fig. f). You should hear a click.

- Pull on connector to be sure it is locked onto the anchorage.

- Repeat for connector on opposite side. (fig. f)

11Tighten lower anchorage belt to secure the base. Press down in center of base to depress the vehicle cushion and pull free end of lower anchor belt to tighten belt around base (fig. g).

Check for secure installation. Pull base front to back and left to right to check for secure installation (fig. h). LATCH belt MUST stay tight.

If LATCH belt does not stay tight or base can not be securely		(fig. g)	(fig. h)
installed, try a different LATCH location or use the vehicle’s
seat belt to secure the base.	24