8040 (EN) 122904.qxd 12/29/04 9:17 PM Page 35
Installation with Lap And Shoulder Belts:
• When using vehicle lap and shoulder belts, shoulder belt may | Shoulder |
be used for additional support. Place shoulder belt around | Belt Guide |
| |
back of Combi Connection™ (fig. e) and through the vehicle |
|
shoulder belt guide on back of car seat shell (fig. f). If |
|
shoulder belt is too short to go around back of Combi |
|
Connection™, position shoulder belt against vehicle seat |
|
back (fig. g). Do not route shoulder belt through lap belt |
|
guides on either side of car seat. | (fig. f) |
(fig. e) |
• Lap/shoulder belt with free sliding latch plate:
- Pull out on latch plate (fig. h). If belt slides freely through latch plate, a locking clip must be used as described in “Locking Clip” section.
- Some combination lap/shoulder belts with free sliding latch plates may be converted into an “automatic locking mode” that will allow use without a locking clip. See vehicle owner’s manual and label on vehicle belts for instructions.
34 | (fig. g) | (fig. h) |
