Chapter 2 Getting Started

4.Double-click on the TCP/IP connection, the TCP/IP configuration window shall be displayed, as shown in Figure 2.2.2-5.

Type in the IP Address and Subnet Mask of 192.168.168.X and 255.255.255.0 espectively. Type in the Default gateway as 192.168.168.1. Type in the IP address of your DNS server in the Preferred DNS Server field.

Figure 2.2.2-5

Network Configuration

Window

5.Press the OK button again to close the network configuration window. The new network configuration will be registered on your network card.

2.3Connecting to the Configuration Interface

Compex NetPassage 15B is integrated with an embedded HTTP Server to provide a user-friendly web-based configuration interface. Alternatively, you may also connect to the Command Console of NetPassage 15B via a TELNET session or a direct serial connection.

This section assumes that the IP address of your NetPassage 15B has not been changed. It is still the default IP of 192.168.168.1.

This section also assumes that the TCP/IP settings of your computer have been configured properly. To make sure that the TCP/IP of your computer has been configured properly, perform the following command at the DOS prompt:

C:\WINDOWS\PING 192.168.168.1

If you receive replies from the above command, it indicates that your computer has been properly configured with TCP/IP.

13

Page 20
Image 20
Compex Technologies NetPassage 15B manual Connecting to the Configuration Interface, Windows\Ping