CONAIR
MARTIN
7.Servicing
All servicing work should be carried out by a qualified service engineer and in the order described, to prevent personal injury or damage to machinery.
7.1Changing the knives
When changing the knives, also check for any wear to the screen. For safety reasons, this should be replaced when the holes in the screen become drop- shaped.
Always take great care when handling the knives since they are very sharp and can cause personal injury. Use protective gloves!
7.1.1Changing the fixed and rotating knives
For safety reasons, damaged screws must be replaced.
•Open the granulator as described in chapter 5.2.
Disassembling the rotating
knives (G):
1.Remove the fastening screws (C) and washers.
Disassembling the fixed
knives (H):
1.Remove the screws (D) and washers.
Assembling the lower fixed
knife:
1.Check that the knives and the grooves where the knives are to be placed are free from plastic waste, grease, etc.
2.Place the lower fixed knife in position and gently tighten the screws (D)Ê with washers.
3.Position the fixture for adjusting the lower fixed knife and push the knife's edge against it.
4.Tighten the screws (D) so
that the knife does not move and release the fixture.
5.Tighten the screws (D) using a torque of 220 Nm.
0 5 - 1 5 - 9 6 | 7 9 | 12 |
