CONAIR
MARTIN
6.3Cleaning
NOTE: Set the main
Always take great care when handling the knives since they are very sharp and can cause personal injury.
1.Open the hopper and screenbox as described in chapter 5.2.
2.Clean the hopper, screen and granule bin.
3.Clean the
4.Be sure to clean the groove (6) between the gear and cutter housing and remove any material which may get into the gear.
5.Replace all parts in reverse order.
Note: Steps 2 - 5 should be carried out every time the machine is cleaned,
or at least once every 300 hours.
6.4Trouble-shooting
6.4.1If the granulator does not start
•Check that the saftey switches’ break loops are completely pushed in.
•Check that the emergency stop is not activated. It can be reset by turning the button in the direction of the arrow.
•The bimetal relay F1 in the electrical cabinet, according to the diagram opposite, is released if you press stop or overload the granulator. This is indicated by the small
green rectangular pin (P), which sticks up
above the surface of the bimetal relay. WhenP you reset by pressing the "Reset" button, the
pin (P)Ê is pushed back in so that it is level with the surface of the bimetal relay.
0 5 - 1 5 - 9 6 | 7 9 | 11 |
