Connect Tech CTIM-00043 user manual J3B, J4 and J5

		CANpro/104 User Manual
J3B
Position	Function
	Jumper Installed	Jumper Removed
1	Mem Addr[16] or I/O Addr[9] = 1	Mem Addr[16] or I/O Addr[9] = 0
2	Mem Addr[15] or I/O Addr[8] = 1	Mem Addr[15] or I/O Addr[8] = 0
3	Mem Addr[14] = 1	Mem Addr[14] = 0
	or	or
	I/O Addr[7] = 1 (BasicCAN mode only)	I/O Addr[7] = 0 (BasicCAN mode only)
4	Mem Addr[13] = 1	Mem Addr[13] = 0
	or	or
	I/O Addr[6] = 1 (BasicCAN mode only)	I/O Addr[6] = 0 (BasicCAN mode only)
5	Memory Space Enable Bit-2 [Note 1]
6	Memory Space Enable Bit-1 [Note 1]
7	Memory Space Enable Bit-0 [Note 1]

Table 21

The 3 Memory Space Enable bits select 8 choices of I/O Addresses for the Memory Enable feature.

J3C

Position	Function
	Jumper Installed	Jumper Removed
1	Memory Space powers-up (or resets)	Memory Space is always enabled
	disabled
2	BasicCAN mode enabled	PeliCAN mode enabled
3	CAN-1 Interrupt Shared	CAN-1 Interrupt Not Shared
4	CAN-0 Interrupt Shared	CAN-0 Interrupt Not Shared
5	Shared Interrupt(s) Pull-Down enabled	Shared Interrupt(s) Pull-Down disabled
6	Shorten Memory and I/O Bus Cycles	Normal Memory and I/O Bus Cycles
Table 22

J4 and J5

Position	Function
	Jumper Installed	Jumper Removed
T	CAN Bus Termination Resistor enabled	CAN Bus Termination Resistor disabled
G	9D Connector Shell Grounded [Note 1]	9D Connector Shell NOT Grounded

Table 23

The 9D Shell is Grounded to the Isolated Ground for the respective CAN Port.

17	www.connecttech.com	CTIM-00043 (0.01) 1/15/2010
	800-426-8979 519-836-1291