Craftsman 107.2777 manual Clean Deck & Check / Replace Mower Blades, injury, Workbench

CLEAN DECK &

CHECK / REPLACE MOWER BLADES

Service Intervah 25 hours or as required.

J

J

WARNING

For your personal safety, do not handle the sharp mower blades with bare hands. Careless or improper handling of blades may result in serious

injury.

WARNING

For your personal safety, blade mounting

capscrews must each be installed with a

hex/spline washer and spring washer, then securely tightened. Torque blade mounting capscrew to 45 - 55 ft. Ibs. (61 - 75 N.m.)

1.Remove mower deck (see "Mower Deck Removal" in the OPERATION section).

2.See Figure 18. Remove blade to inspect it or to safe- ly access the underside of the mower deck. Use a block of wood to prevent blade rotation while loosen- ing the capscrew by turning it counterclockwise.

3.Remove the capscrew (D, Figure 20), spring washer (C), hex washer (B), and blade.

4.Clean the underside of the mower deck.

5.Inspect the blades for nicks or dull edges. Use a file to sharpen blade to a fine edge. If the blade is dam- aged, it must be replaced.

6.Balance the blade as shown in Figure 19. Center the

blade'shole on a nail lubricated with a drop of oil. A balanced blade will remain level. If the blade is not

balanced, continue to sharpen the heavy side until it balances.

7.Reinstall the blade with the lift wings (E, Figure 20) pointing up toward the mower deck as shown.

8.Reinstall the hex washer (B, Figure 20), spring wash- er (C) and capscrew (D). Use a wooden block (A) to prevent blade rotation while tightening the capscrew

(D)to 45-55 ft. Ibs. (61-75 N.m). Turn capscrew clockwise to tighten.

LOOSEN

Figure 18. Blade Removal

Workbench

Nail

Figure 19. Balancing The Blade

Figure 20. Blade installation

A. 4x4 Wood Block

B.Hex Washer

C.Spring Washer

D.Blade Capscrew

E.Lift Wings

2O