Craftsman 107.2777 manual Cleaning The Battery And Cables, Check Rider Safety System

CLEANING THE BATTERY AND CABLES

WARNING

Be careful when handling the battery. Avoid spilling electrolyte. Keep flames and sparks away from the battery.

When removing or installing battery cables, disconnect the negative cable FIRST and reconnect it LAST. if not done in this order, the positive terminal can be shorted to the frame by a tool.

Always wear safety glasses and gloves when handling batteries.

Service interval: 200 Hours

1.Disconnect the cables from the battery, negative cable first (B, Figure 21).

2.Remove the rubber strap securing the battery, and remove the battery.

3.Clean the battery and battery compartment with a solution of baking soda and water.

4.Clean the battery terminals and cable ends with a wire brush until shiny.

5.Reinstall the battery and secure with the rubber strap.

6.Reattach the battery cables: first attach the positive cable (see A, Figure 21), then attach the negative cable (B).

7.Coat the cable ends and battery terminals with petro- leum jelly or non-conducting grease.

CHECK RIDER SAFETY

SYSTEM

Service Interval: 200 Hours & Every Spring/Fall

This unit is equipped with safety interlock switches. These safety systems are present for your safety. Do not attempt to bypass safety switches, and never tamp- er with safety devices. Check their operation regularly.

Operational SAFETY Checks

TEST 1 -- ENGINE SHOULD NOT CRANK IF:

•PTO switch is ON, OR

Parking brake is in DRIVE position, OR

Ground speed control levers are not in their PARK positions.

TEST 2 -- ENGINE SHOULD CRANK IF:

•PTO switch is OFF, AND

Parking brake is in PARK position, AND

Ground speed control levers are locked in their PARK positions.

TEST 3 -- ENGINE SHOULD SHUT OFF IF:

•Operator rises off seat with the PTO ON, OR

•Operator rises off seat with the parking brake in DRIVE position, OR

•Operator moves the ground speed control levers out of their PARK positions before setting the park- ing brake to DRIVE.

TEST 4 -- BLADE BRAKE CHECK

The mower blades and mower drive belt should come to a complete stop within five seconds after the PTO switch is turned OFE If mower drive belt does not stop

within five seconds, contact a Sears Parts & Repair Center.

NOTE: Once the engine has stopped, the PTO switch must be turned OFF, parking brake must be set to PARK, and the ground speed control levers must be locked in their PARK positions in order to start the engine.

Figure 21. Engine Compartment

A. Positive (+) Battery Cable

B. Negative (=) Battery Cable

WARNING

if the unit does not pass a safety test, do not operate it. See a Sears Parts & Repair Center. Under no circumstance should you attempt to defeat the purpose of the safety interlock system.

21