DUSTBOX/ DUST COLLECTION

/_, WARNING: Collected sanding dust from sandJingsurface coatings (polyurethane, linseed oil, etc.) can self-ignite in sander dust box or elsewhere

and cause fire. To reduce risk, empty dust box frequently and strictly follow sander manual and coating manufacturer's instructions.

/_ WARNING: When working on metal surfaces, DO NOT use the dust box or a vacuum cleaner because sparks are generated. Wear safety glasses and a

dust mask. Due to the danger of fire, do not use your sander to sand magnesium surfaces. Do not use for wet sanding.

CYCLONIC DUST/AIR SEPARATOR (CDS) COLLECTmON SYSTEM

Dust Box features advanced air flow design with centrifugal force dust extraction that separates the dust particles from the air flow as they enter the box. The clean air then flows out of the box while the dust particles are trapped inside. This system provides more efficient dust collection than the standard dust bag system.

TO REMOVE AND EMPTY DUST BOX (See Fig. 4)

1.Unplug the sander.

I/_ WARNING: Failure to unplug the sander could result in accidental starting I causing possible serious personal injury.

2.Locate two tab connectors on either side of cyclonic dust box and squeeze together. This disconnects dust box from sander.

3.Slide dust box off sander dust exhaust.

4.Cyclonic Dust box has black button on rear that pusl_es in to open a small door in rear

of box (see Fig. 4a). Dust can be emptied from this door. Shake box aggressively to completely empty. To close door, simply push in until it clicks shut.

 

two tab connectors on sides catch

F'_.

 

 

on to sander. You will hear them click.

 

 

6.

Your sander

is now ready to use.

 

 

5.

To reattach

dust box, push box until

__,___. __

h

Door ,on rear of Cyclonic Dust Box

--'-

14

Page 14
Image 14
Craftsman 172.27673 operating instructions DUSTBOX/ Dust Collection, To Remove and Empty Dust BOX See Fig Unplug the sander