Craftsman 320. 28180 operating instructions General Maintenance, Problem, Cause

GENERAL MAINTENANCE

,_ WARNING" Avoid using solvents when cleaning plastic parts. Most plastics

are susceptible to damage from various types of commercial solvents and may be damaged by their use. Use clean cloths to remove dirt, dust, oil, grease, etc.

,_ WARNING; Do not at any time let brake fluids, gasoline, petroleum-based products, penetrating oils, etc., come in contact with plastic parts. Chemicals can damage, weaken or destroy plastic, which may result in serious personal injury.

WARNING" Always wear safety goggles or safety glasses with side shields

during power-tool operation or when blowing dust. If the operation is dusty, also wear a dust mask.

PROBLEM

The router does not work

The table surface is not flat

The router can not

be attached to the table

CAUSE

The router is not plugged into the table outlet.

The router-table cord is

not connected to a power source

The Router switch is in "OFF" position,

Legs are not properly as- sembled,

Work surface is not flat.

Sub-base is too large

SOLUTION

Insert router power cord plug into a table outlet

Plug the router-table cord into a power source

Insert key and pull the switch to the ON position

Check assembly directions and securely tighten all fasteners

Place router table on a flat, level surface

Use a sub-base 6-7/8 in. in diameter or less.

28:$80 Manual_Revlsed_07-O228 Page 22