Crown 137769-3 Setup, Unpack and Install Your DBC Network Bridge, Connecting to AC Mains

3 Setup

3.1 Unpack and Install Your

DBC Network Bridge

Please unpack and inspect your product for any damage that may have occurred during transit. If damage is found, notify the transportation company immediately. Only you can initiate a claim for shipping damage. Crown will be happy to help as needed. Save the shipping carton as evidence of damage for the shipper’s inspection.

We also recommend that you save all packing materials so you will have them if you ever need to transport the unit. Never ship the unit without the factory pack.

YOU WILL NEED (not supplied):

• Input wiring cables

• Network cables

• Rack for mounting the DBC Network Bridge (or a stable surface for stacking)

WARNING: Before you start to set up your DBC Network Bridge, make sure you read and observe the Important Safety Instructions found at the begin- ning of this manual.

DBC Network Bridge

CAUTION: Before you begin, make sure your DBC Network Bridge is discon- nected from the power source.

Use a standard 19-inch (48.3 cm) equipment rack (EIA RS-310B). See Figure 3.1 for dimen- sions.

You may also stack units without using a cabinet.

NOTE: When transporting, units should be sup- ported at both front and back.

3.2 Connecting to AC Mains

WARNING: The third (ground) prong of the AC power cord connector is a required safety feature. Do not attempt to disable this ground connection by using an adapter or other methods.

Figure 3.1 Dimensions

page 16 Operation Manual