Crown 137769-3 Presets, Label, Preset Segue, Verify Recall or Store, Preset Options Notice

DBC Network Bridge

4 Operation

4.7.10 Presets

Click on the Unit Presets tab to open the Presets window (Figure 4.16).

The DBC Network Bridge has the ability to reconfigure itself with a single command. Thirty-two	1
'Presets' can be stored and recalled via a variety of means including the front panel, a Control Port
Input, or a scheduled 'Event'. Preset 32 is the standard cinema setup, which works in most
cases. Preset 32 is explained under number 6 below.
1. Store

3

2

For a Preset to be stored, all of the individual controls needs to be set up using IQwic while on- line to the DBC Network Bridge, then press the 'Store' button and a select a Preset.

To ensure that settings are not inadvertently lost due to selecting a Preset instead of storing a Pre- set, the “Prompt to recall or store” checkbox allows a query window to display whenever a Preset button is pressed in order to ensure the intent of the user.

2. Label 4

Each Preset has a 32 character user-definable label.

3. Preset Segue

This enables smooth level transitions between Presets. When a Preset is selected, all of the fader settings are changed at a rate that is determined by the ‘Preset Segue Settings’ box. The rate of change can be either a 'Fixed Time' that is selectable from 0 second to 255 seconds or a 'Fixed Rate' that goes from 0.5 dB/sec to 40 dB/sec.

4. Verify Recall or Store

When you click on a Preset number, this window appears so that you can recall the selected Pre- set, store it, or cancel.

5. Preset Options Notice

Right-click on preset numbers to open more options: Load or save Presets to file, cut or copy Pre-

sets to clip area, and Edit Presets. Selecting Edit Presets opens the Preset Editor window6 described on page 38.

6. Standard Cinema Preset Button (Preset 32) 5

Pressing this button recalls the preset for a standard cinema setup: a read-only preset that cannot be edited by the user. If you want to create a preset based on Preset 32 but with changes, save it to another Preset. The Standard Cinema preset contains the following settings in the DBC Network Bridge:

Figure 4.16 Presets Window

•The input is set to analog; the outputs are set to –20 dB.

•The Monitor is set to Ch1 at 0 dB.

•The CobraNet output for L, R, C, SW is set to TxA on Bundle 100 at 24 -bit.

•The CobraNet output for SL, SR, BSL, BSR is set to TxB on Bundle 200 at 24-bit.

•The CobraNet input for all eight input channels set to TxA on Bundle 300.

Operation Manual page 37