•If food tends to stick to the sides of the blender jar when blending, pulse in short bursts.
•Pulses should be short bursts. Space the pulses so the blades stop rotating between pulses.
Don’t:
•Don’t store food or liquids in your blender jar.
•Don’t place cutting assembly and locking ring onto motor base without the blender jar attached.
•Do not attempt to mash potatoes, knead heavy dough,
or beat egg whites. These can be done in the Food Processor.
•Don’t remove blender jar while unit is on. Keep the blender jar cover on the blender jar while blending.
•Don't twist locking ring from blender jar when removing blender jar from motor base. Simply lift blender jar from motor base.
•Don’t overprocess foods. Blender will achieve most desired results in seconds, not minutes.
•Don’t overload blender. If the motor stalls, turn the blender off immediately, unplug the unit, and remove a portion of the food, then continue.
•Don’t use any utensil inside the blender jar while the motor is on.
•Don’t use any container or accessories not recommended by Cuisinart®. Doing so may result in injury.
•Don’t place hands inside the blender jar when blender is plugged in.
•Don’t add boiling liquids or frozen foods [except ice cubes or
FOOD PROCESSOR FEATURES
1
1.Food pusher with oil dispenser
2. Work bowl cover with | 2 |
| |
feed tube |
|
3. | Stainless steel | 3 |
| chopping blade | |
|
| |
4. | Stainless steel reversible | 4 |
| slicing/shredding disc |
|
|
| 5 |
5.Adapter stem
6. Clear work bowl | 6 |
7.Gearbox collar
7
8. Motor base
Used for both the blender | 8 |
jar and the food processor bowl
FOOD PROCESSOR
GETTING STARTED STEP BY STEP
Please note that the bowl with collar will fit on the base in eight different positions. The handle can be in front or on either side and the feed tube in front, back, or on either side. Directions for use reference a certain position for instructional purposes only.
FOOD PROCESSOR ASSEMBLY
CHOPPING, PURÉEING AND MIXING
1.Hold gearbox collar in one hand and work bowl handle in the other. Twist bowl clockwise onto collar.
2.Place collar with bowl onto motor base with handle facing front.
3.Place chopping blade over shaft in work bowl. Chopping blade should slide easily to the bottom of the bowl. Lower blade will almost touch bottom of bowl.
BE SURE TO HANDLE THE METAL BLADE WITH CARE AS IT IS RAZOR SHARP!
4.Place food to be processed in work bowl. Put cover on work
8
