Getting Started - Powering On & Playing a Disc
After Video and Audio Cables are Connected and the power cord is plugged in
Once the DVD Player is properly connected to your TV and possibly your receiver also, turn on your TV and make sure it’s set to the correct input channel. The video input is usually configured as channel 0 or 1 on most TVs, but may be referred to as “Input 1” or “Aux In” or similar names. These procedures assume you are using a NTSC- compatible TV - standard for North and South America. If you are using a
1 | ON |
I | |
O | |
OFF |
2 
OR
POWER
2
Power on the DVD Player *
Push the Power Button on the back of the unit firmly to turn on the player. You should see the STATUS LED “ON” on the front bezel of DVD Player.
Powering on with the 
Front Switch
Once the main power switch on the back of the unit is on, the Front power switch can be used to bring the player in and out of STANDBY MODE. Note: the STATUS LED is RED in STANDBY MODE and GREEN when Power ON.
Powering on from the Remote
Once the back power switch is in the ON position, the unit can be turned off and on by the remote. When the unit is turned off by the remote, it will go into STANDBY MODE. This allows the unit to be quickly “awakened” by pressing the POWER key on the remote again.
2
POWER | DISPLAY | SETUP | OPEN/CLOSE | 3 |
TITLE | MENU | GOTO | PROGRAM | |
| PBC |
| MUTE | |
ANGLE | SUBTITLE | AUDIO | 4 | |
|
|
| PLAY | |
| ENTER |
| STOP | |
|
|
| PAUSE |
|
RETURN | BOOKMARK | ZOOM | SLOW |
|
|
|
| 1/ALL |
|
|
|
| REPEAT |
|
|
|
|
| |
|
|
| EFFECTS |
|
|
|
| INTRO |
|
10+ 
3 |
| Opening the Disc Tray |
OPEN/CLOSE | Press the OPEN/CLOSE button on the remote or on the | |
| ||
| player (to the right of the disc tray) to insert a disc. There are | |
| two grooves in the disc tray - 12cm and 8cm. Make sure the |
disc is properly set into the tray. Small 8cm discs must be positioned exactly in the middle groove. Press the OPEN/CLOSE button again (Remote or Player) to close the disc tray. You will see the “ 
“ message READ on the top right TV display. Once the disc is read, you should see the menu screen for DVD discs, hear sound for an Audio CD or a menu should appear. Note: STANDBY LED will blink GREEN when reading the disc. When LED is not blinking the player has recognized the disc loaded.
4 |
| The Play Button |
PLAY | Most DVDs will automatically display a menu when inserted. | |
| ||
| However, some discs will require you to press the PLAY | |
| button. Also, the PLAY button can usually be used to quickly |
start a DVD movie when pressed with the menu displayed. This function varies with discs.
Note: We have added shortcuts in powering on the player from STANDBY. Press the Open/Close or Play buttons on the REMOTE or PLAYER to wake up the system and execute the pressed function. These shortcuts will turn ON the player and open the disc tray or begin to play the disc already in the player.
Quick Tips
About Standby Mode
ŸYour DVD Player is equipped with a power- saving feature called STANDBY MODE. When you press POWER on the Remote to turn off the unit, it will enter standby mode, indicated by a glowing RED LED on the Status LED right of the disc tray, where it can be quickly awakened by pressing POWER, PLAY or EJECT buttons
*Some models of the players may vary in specifications. Should your player not have the rear power switch and the
power cord is attached to the player, please skip this step.
14
