Connect the Ethernet Cable | D-Link DCS-1130 manual

Section 3 - Installation

Connect the Ethernet Cable

Connect one end of the blue ethernet cables included in your package to the ethernet port on the back of the DCS-1100/1130 camera. Connect the other end of the cable to an available LAN port on your router or broadband modem.

Connecting to a router

Connecting to a broadband modem

Connect the Power Adapter

Attach the power adapter to the power jack located on the back of the DCS-1100/1130 and connect the power adapter to a power outlet. After connecting the power adapter, you should see the status LED on the front of the camera turn on.

The status LED will light red when it receives power, will light green after the camera connects to the network, and will flash green when the camera is being accessed.

D-Link DCS-1100/1130 User Manual

15

Image 20

D-Link DCS-1130 manual Connect the Ethernet Cable, Connect the Power Adapter, Connecting to a router

Contents

Page Manual Overview Revision Date Manual RevisionsTrademarks Table of Contents Table of Contents Warranty Registration Product Overview Features Product Overview Package Contents System Requirements Network RequirementsComputer with the following Browser Requirements Hardware Overview Front Connects to the wireless antennas Back Mydlink Portal Camera Status Live Video Camera Settings Camera Info Installation Starting the Camera Installation Wizard Connect the Camera to the Camera Base Hardware InstallationAttach the Antennas DCS-1130 only Connect the Ethernet Cable Connect the Power AdapterConnecting to a router WPS Wireless Network Connection DCS-1130 only Using the Configuration Menu Web-based Configuration Utility Live Video Camera Setup Setup Wizard Setup Network Setup Configuration Setup Wireless DCS-1130 only Ssid The Ssid of the wireless access point you wish to use Setup Dynamic DNS Setup Image Setup Setup Audio and Video Configuration Configuration Setup Motion Detection Setup Time and Date Setup Recording Recording Options Continuous This will set the camera to record continuously Setup Snapshot Configuration Configuration Maintenance Maintenance Admin Configuration Maintenance System Maintenance Firmware Upgrade Status Status Device Info Status Log Help Troubleshooting What is Remote Access? How do I enable it? What can I do if I forget my password? Installing the DCS-1100/1130 on a Router Without UPnP Identify Your Camera on the Network Assign an IP Address and Port for Your Camera Open the Http Port Router Setup Use Port Forwarding to Enable Remote Image Viewing Select TCP under Traffic Type Viewing Your Camera Over the Internet Viewing Your Camera Over the Internet Behind a Router Technical Specifications Audio Codec Storage Temperature PowerDimensions WxDxH Weight Contacting Technical Support For customers within the United States Warranty Limited Warranty Submitting a Claim USA Limited Software WarrantyNon-Applicability of Warranty Submitting a Claim Canada What Is Not Covered Disclaimer of Other Warranties Limitation of Liability Governing LawTrademarks Copyright Statement FCC Caution CE Mark WarningFCC Statement Industry Canada Statement Important Note Registration