Advantages of Cut-Through | D-Link DES-3216 manual

10/100 Auto Negotiation Switch User’s Guide

byte packets are delayed by 1200 microseconds in a Store and Forward device versus 60 microseconds in a Cut-Through device.

Store and Forward requires more memory because the DES-3216 must store the packet before sending it out.

Advantages of Cut-Through

Cut-Through is faster because the packet is sent as soon as the first 128 bytes are received.

Cut-Through requires less memory since the DES-3216 only reads the address but does not store the entire message.

Disadvantages of Cut-Through

Bad packets are perpetuated, taking up bandwidth.

The benefits diminish in high traffic networks.

Cut-Through can not be used on networks that use both Ethernet and Fast Ethernet. The network must use one or the other.

Follow these steps to change the default setting from Store and Forward to Cut-Through:

1.Toggle the space bar to change the setting.

2.Select Save and press Enter.

Managing the DES-3216

27

Image 35

D-Link DES-3216 manual Advantages of Cut-Through, Disadvantages of Cut-Through

Contents

DES-3216 10/100 Auto Negotiation Switch User’s Guide Link Limited Warranty Hardware North, Central, and South America FCC Warning Wichtige Sicherheitshinweise Table of Contents Page Page Organization About This GuideAudience Introduction Features Rear Panel Front Panel Telnet Management Management MethodsUpdating Firmware Local Console Management Desktop/ Shelf Installation Installing the DES-3216Installation Options Rack Installation Power On Cable Specifications Connecting the DES-3216 to the Network Cable Diagram MDI-X Port Connecting the DES-3216 to the DES-5024 and HubsPorts DES-3216 to DES-3216 Connection LEDs LQN DES-3216 LED Panel Power LED LED Local Console Management Managing the DES-3216 ∙ Data bits ∙ Parity None ∙ Stop bits ∙ Flow Control None Telnet Log ∙ Default User Name D-Link ∙ Default Password D-Link Help Message Help Message Spacebar Panel Conventions Console Program System ConfigurationSwitch Port 1-8, 9-16 Configuration Spanning Tree Configuration Trunking Port Management Snmp Management ConfigurationVlan Port Management System Information System Configuration MenuSystem Reset Factory Reset to Default Config Values Hardware Revision Software UpdateBoot Prom Firmware Version System Information Menu System Description LAN Default GatewaySoftware Version MAC Address System Reset System Reset Factory Reset Factory Reset Factory Reset Confirmation Disadvantages of Store and Forward System Rate ControlAdvantages of Store and Forward Disadvantages of Cut-Through Advantages of Cut-Through Software Update Software Update Menu Software Update Transfer File Transfer through Xmodem Create New User User Account ManagementUser Account Change Menu User Name PasswordConfirm Password Access Level Delete Delete UsersStatus Change Password Change Password New Password Old Password Switch Port Configuration Physical Switch Port Configuration MenuState Priority Port State Spanning Tree Algorithm Spanning Tree ConfigurationSpanning Tree Configuration Menu STA Operation Levels Hello Time Forward Delay TimeBridge Priority Root Cost User Selective STA parameters Root Port Snmp Management Configuration Menu Snmp Management Configuration Snmp Community String Snmp Manager SettingAccess Right Link Change Event Snmp Trap Manager SettingAuthentication Failure Cold StartPage Vlan Port Management Menu Vlan Port Management Vlan Port Management menu TrunkGroup Create New VlanNew Vlan Name Port # Vlan Name Delete Vlan Menu Virtual LAN Name Modify Vlan Menu Trunking Port Management menu Trunking Port Management Menu Name Create New Trunking PortNew Trunking Group Name Trunking Port Delete Trunking Port Trunking Port Name Modify Trunking Port Problem Solution TroubleshootingPage Port Specifications Appendix a DES-3216 Technical SpecificationsSwitch Specifications 10/100 Auto Negotiation Switch Users’ Guide General EMI 10/100 Auto Negotiation Switch Users’ Guide Performance Index Access Level User Name 32, 33