D-Link DWS-3000 manual Quick Start up User Account Management

1 Getting Started

Quick Start up User Account Management

Table 3. Quick Start up User Account Management

Command	Details
show users	Displays all of the users who are allowed to access the network-
(Privileged EXEC Mode)	ing device
	Access Mode - Shows whether the user is able to change
	parameters on the networking device(Read/Write) or is only
	able to view them (Read Only).
	As a factory default, the admin user has Read/Write access and
	the guest user has Read Only access. There can only be one
	Read/Write user and up to five Read Only users.
show loginsession	Displays all of the login session information.
(User EXEC Mode)
users passwd <username>	Allows the user to set passwords or change passwords needed
(Global Config Mode)	to login
	A prompt appears after the command is entered requesting the
	user’s old password. In the absence of an old password, leave
	the area blank. The user must press Enter to execute the com-
	mand.
	The system then prompts the user for a new password; then a
	prompt to confirm the new password. If the new password and
	the confirmed password match, a confirmation message is dis-
	played.
	A user password should not be more than eight characters in
	length.
write	This command saves passwords and all other changes to the
(Privileged EXEC Mode)	device.
	If you do not save the configuration by entering this command,
	all configurations are lost when a power cycle is performed on
	the networking device or when the networking device is reset.
logout	Logs the user out of the networking device.
(User EXEC and Privileged
EXEC Modes)

Unified Switch Installation 23