Dacor Self-RimmingInstallation With Raised Vent, ERV3015, Top View, Side View, Raised Vent, Model DR30DI, 3 1/4 Inch Side Panels NotRemoved

Planning the Installation

Self-Rimming Installation With Raised Vent

•Only model DR30DI may be installed with a raised vent. Use only Dacor raised vent model ERV3015.

•A self-rimming countertop configuration is required for raised vent installation. On installations with a raised vent, when sliding the range into position, it will stop when the rear of the control panel or side panels contact the notches toward the front of the countertop.

•The self-rimming installation of the DR30DI range and ERV3015 raised vent create a “built-in” look where the range trim overlaps the countertop on both sides and the raised vent overlaps the countertop in back. It is also possible, if the cabinets are deep enough, to self rim the front of the range into the cabinet face immediately behind the control panel and door trim or behind the side panels (see side views on this and the facing page). The rear range trim will partially cover the front of the raised vent chassis in back.

Model DR30DI
Range and
ERV3015	H	J	K
Raised Vent
With
Countertop self-	20 5/8”	0” (0 cm) to	0” (0 cm) to
		3 1/4”
rimmed only	(52.4 cm)		5 3/8” (13.7 cm)
		(8.3 cm)
Countertop and	20 5/8” *	NA	0” (0 cm) to
Cabinet Front
	(52.4 cm)		5 3/8” (13.7 cm)
Self-Rimmed,
Countertop and
Cabinet Front	23 7/8” *	NA	0” (0 cm) to
Self-Rimmed (side	(60.6 cm)		2 1/8” (5.4 cm)
panels removed)

*Cabinet face below countertop must be flush with back of notch in countertop.

Cutout tolerances: +1/16” (+1.6 mm), -0

Model DR30DI/ERV3015 Countertop Self-Rimmed Only,3 1/4 Inch Side Panels Not Removed

Non-combustible

10” min.

3/8” min. (1.0 cm)

countertop

(25.4 cm)

rear wall recommended

overhang

both sides

2 9/16”

27 1/2” (69.9 cm)

raised vent opening

(6.5 cm)

29 1/4” (74 3 cm)

countertop opening

30” (76.2 cm)

cabinet opening

H

below countertop

Combustible side

wall above range

J

K

Notch countertop

overhang to width of

cabinets

To countertop

To cabinet face

below countertop

front

Top View

28 11/16” (72.9 cm)

3/8” min. (1.0 cm)
flat countertop	Range trim resting
overhang required
behind cutout	on countertop

Countertop height for all self-rimming installations:

35 7/16” (90.0 cm) minimum, 37 7/16” (95.1 cm) maximum

IMPORTANT: If the 3 1/4 inch side panels are removed, the cabinet face must be flush with the back of the control panel.

ERV3015 raised vent

Countertop

H DR30DI[H] range

3/8” min. (1.0 cm) space required behind ERV3015 chassis to clear stiffener

Cabinet face

Back of

control

panel

3 1/4 inch side panel

Side View

8